PPM3 MKII Programmer
- User Guide - V1.04 - 10
th
May 2008
40
2.6.5 Programmer Status LED’s
The current status of the programmer is displayed on the programmer Status LED’s as detailed in the
table below.
Fig. 2.6.5 Programmer Status LED’s – state descriptions
Status LED
Display
State
State Description
WAITING
•
Programmer is now waiting to start an
‘Autoprogram’ operation.
BUSY
•
Programmer is ‘BUSY’ performing a
programming operation.
•
If the programmer is controlled from
EDS, the BUSY LED will remain on
after a programming operation until a
‘RESET programmer’ command is
executed.
FAIL
•
Programming operation has FAILED.
•
See programmer LCD for diagnostics
•
Programmer will automatically switch off
target power if it is controlling power.
PASS
•
Programming operation was successful.
Status LED key:
Please note:
There are also two special modes called
‘Waiting Target Connection’
or
‘Waiting Target
Disconnection’
where the yellow BUSY LED will FLASH. These modes are enabled when ‘Target
Connection Sense’ is enabled in the Programming Project.
Summary of Contents for PPM3 MK2
Page 1: ...User Guide...
