PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008
21
5
Testing the programmer for the first time
5a
Apply power to the programmer
Æ
Programmer circuitry powers up to 5.0V.
Æ
FAIL LED flashes to indicate that the
programmer has rebooted.
Æ
The programmer display now initialises to
show the programmer type, firmware version
etc. See 5(b), 5(c), 5(d).
5b No Programming Projects Loaded
NO / INVALID
PROJECT LOADED!
•
If the programmer has never been used
before or the on-board FLASH Memory
Store has been erased, then the
programmer will display the message:
‘No / Invalid Project Loaded’.
•
It is not possible to check the
programmer information until a valid
project is uploaded. Please upload a
valid project to the programmer using
EQTools and then try again.
5c
Check the programmer firmware version
EQUINOX-TECH UK
PPM3 Ver:-2.37
•
The programmer display now shows the
programmer type and the firmware
version.
e.g. 2.37.
•
You can check that you have the very
latest firmware version by viewing the
‘Configit – Firmware Update Utility’ on
the Equinox website.
5d Check the programmer serial number,
build revision and build date
SN:619 1.05
DATE 9-2-2003
After 2 seconds the display will update to show
the following information:
•
Serial Number (SN): eg. 619
•
Hardware Build Version: eg. 1.05
•
Build date: eg. 9 /2/2003
6
Hardware installation is now complete.
Summary of Contents for PPM3 MK2
Page 1: ...User Guide...
