PPM3 MKII Programmer
- User Guide - V1.04 - 10
th
May 2008
10
1.6 Programmer Specifications
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
Parameter
Description / comment
Refer
to
section
1 Target
Device
Support
See Device Support List
1.7.1
2 Target
Device
Programming
Interfaces
The programmer supports the following programming
interfaces:
•
Atmel Low Voltage SPI
•
Atmel High Voltage SPI (+12V Vpp)
•
Atmel AVR JTAG (chargeable update)
•
Atmel (formerly Temic) 8051 Boot loader ISP
•
Philips (NXP) 8051 - Boot Loader ISP
•
Generic I2C (SDA + SCL)
1.7.2
3 Operating
modes
The programmer supports the following operating modes:
•
Development Mode (PC controlled)
•
Project Upload Mode (PC controlled)
•
Standalone Mode - LCD operation
•
Standalone Mode – Automatic Target Connect /
Disconnect Sensing
•
Standalone Mode - Remote Controlled via ‘ASCII Text
Communications’ RS-232 Serial Protocol
•
Standalone Mode - Remote Controlled via 4-wire TTL
Remote Control Port
•
PC controlled via ISP-PRO software (chargeable
upgrade)
•
PC controlled via ConsoleEDS utility (chargeable
upgrade)
2.4
4 On-board
FLASH
Memory Store
32 Mbits (4 MBytes) FLASH Memory
5
Project storage in
Memory Store
64 x Programming Projects
6 Keypad
entry
4 x Push Button - <YES>, <NO>, <UP>, <Down>
7 Status
LED’s
i.
3 x Status LED’s located on the programmer:
<PASS>, <BUSY>, <FAIL>
ii.
3 x remote Status LED’s can also be connected off-
board on a Test Fixture via the ‘Remote System
Status’ port.
8 Programmer
Display
2 x 16 Back-lit LCD
9 Target
Vcc
Voltage Detection
LED
This LED is located on the I/O-CON Module:
•
Target Vcc (POWER) LED will light when Target Vcc is
detected.
•
Threshold detection voltage: approx 3.1V
Summary of Contents for PPM3 MK2
Page 1: ...User Guide...
