PPM3 MKII Programmer
- User Guide - V1.04 - 10
th
May 2008
18
2.2 Hardware Installation Procedure
Please follow the instructions below to set up the programmer hardware:
#
Action
Observation
1a
Ensure you are wearing an ESD strap
and/or you are working in an ESD
protected environment.
The programmer I/O lines are ESD protected,
but it always good practice to take proper ESD
precautions. This can help to avoid ESD
damage to either the programmer or Target
System.
1b Remove programmer from all packaging
and place on a flat surface.
1c
If you are planning to use the programmer
as a desktop programmer, affix the four
stick feet to the base of the enclosure.
The four rubber feet are supplied separately in a
plastic bag.
2
fit I/O Connector Module
2a
Select the required ‘I/O Connection
Module’
eg. EQ-IOCON-1 Module
For full details of which devices / algorithms
each I/O Connection Module supports, please
refer to the separate document ‘PPM3 I/O
Connectors Manual’.
The PPM3 programmer is supplied with two I/O
connection Modules as standard:
•
EQ-IOCON-1
•
EQ-IOCON-2
A module for supporting JTAG programming can
also be purchased as an optional extra:
•
EQ-IOCON-3
2b Fit the selected ‘I/O Connection Module’ to
the programmer
•
Remove selected ‘I/O Connection
Module’ from its packaging.
•
Position the module so that the long red
connector on the back of the module
matches up with the mating connector on
the PPM Module.
•
Gently apply pressure to both sides of
the module until it snaps securely into
place.
Summary of Contents for PPM3 MK2
Page 1: ...User Guide...
