PPM3 MKII Programmer
- User Guide - V1.04 - 10
th
May 2008
8
1.4.3 SFM Module – how to fit a new module
To fit a new SFM Module to the programmer:
•
Make sure the programmer is powered off
•
Remove all cables from the programmer
•
Remove the four fixing screws in the side of the programmer case
•
Carefully slide the lid of the programmer upwards and then off
•
You can find the existing SFM Module underneath the keypad PCB
•
Carefully remove the existing SFM Module by applying pressure from underneath at both
sides of the circuit board
Æ
the SFM module should pop out of the red connectors
•
Fit the new SFM Module in the same position and orientation as the one you have just take
out (make sure to line up the long red connector on the main PCB to the long red connector on
the SFM module
•
Push the new SFM Module down gently until it locks into place
•
Replace the programmer lid
•
Replace the programmer screws
1.4.4 SFM Module – declaring the module in a Programming Project
The EQ-SFM-1 and EQ-SFM-V1.2 / V1.3 modules actually use slightly different firmware in the
programmer. It is therefore necessary to specify which SFM Module is fitted in each Programming
Project.
To specify the correct SFM Module in a Programming Project:
In EDS (Development Mode):
•
Open your EDS (*.eds) development project
•
Select
the
<Programmer and device>
tab
•
Locate
the
‘Special Function Module fitted’
list box
•
Select the relevant SFM Module which you have fitted to your programmer
In Project Builder:
•
Open your Programming Project (*.ppm) project
•
Select
the
<Programmer and Project Type>
tab
•
Locate the ‘Special Function Module fitted’ list box
•
Select the relevant SFM Module which you have fitted to your programmer
•
Re-compile your project to save the changes
Important notes:
•
Failure to specify the correct SFM Module can result in erratic operation of the programmer.
•
If you have existing projects which use the standard EQ-SFM module, these projects will need
to be recompiled for the new EQ-SFM-MAX 1.2 or 1.3 Modules.
Summary of Contents for PPM3 MK2
Page 1: ...User Guide...
