PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008
67
4. Test the Project in Equinox Development Suite (Target System connected)
•
Launch the Project in Equinox Development Suite
•
With your Target System
CONNECTED
, place a Volt Meter across the
Target Vcc
and
GROUND terminals of the programmer (on the I/O Connector Module)
•
Click
the
<Power Up>
button in EDS
Æ
the programmer
<BUSY>
LED should now
illuminate
•
If the programmer reports an error on the LCD and the RED LED is flashing,
•
Measure the voltage across the
Target Vcc
and GROUND terminals of the programmer.
•
If required, measure the voltage across the
Target_Vcc
and GROUND on the actual
Target System
Summary of Contents for PPM3 MK2
Page 1: ...User Guide...
