PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008
11
10 PC
Control
Software
The programmer can be controlled using:
•
EQTools (as standard)
•
ASCII Text Communications Mode (as standard)
•
ISP-PRO (chargeable upgrade)
2.3
11 EQTools / ISP-PRO
PC requirements
PC running Windows 95 / 98 / 2000 / ME / NT4 / XP
2.3
12 Power
Supply
Options
There are 3 possible modes for powering the Programmer /
Target System:
•
Programmer controls power to the Target System
•
Programmer and Target System are independently
powered
•
Target System powers the Programmer (+5V only)
4.0
13 Voltage
range
•
Device Programming voltage range: 3.0 – 5.0V
•
Programmer Controlled Power Supply range: 3.0 – 5.0V
•
Possible Target System voltage range: 3.0 – 5.0V
4.4
14 Vpp
Voltage
Generator
On Board +12.0V Vpp Voltage Generator
(A12.0V to RESET pin for Atmel ATtiny HV
programming)
15 DC
Power
Connector
(jack socket)
DC Power Connector
•
2.5 mm Jack Socket – Centre Positive
•
9.0 – 12.0V DC regulated @ 500mA (worst case)
•
Mates with Power Supply Adaptor supplied with
programmer
•
DC Power Lead also supplied with programmer if a
customer power supply is to be used.
4.2
16 DC
Power
Connector
(Molex)
DC Power Connector
•
2-pin pluggable Molex Connector
•
9.0 – 12.0V DC regulated @ 500mA (worst case)
17 Max. current through
programmer
This refers to the maximum current which the programmer can
supply from the ‘controlled’ power supply.
Max current = 300 mA.
18 Target
SPI
Frequency
Software SPI algorithm:
•
SLOW SPI: 0 – 490.2 kHz (user selectable)
•
MEDIUM SPI: 0 – 490.2 kHz (user selectable)
( SPI speeds are estimations only due to uneven mark/space
ratio and non-continuous waveforms)
Hardware SPI algorithm (requires firmware 3.04 or
greater):
•
SLOW SPI: 115.2 kHz to 3.6864 MHz (user selectable)
•
FAST SPI: 115.2 kHz to 3.6864 MHz (user selectable)
•
SPI speeds > 500kHz require the fitting of the faster
EQ-SFM-MAX V1.2 or V1.3 SFM Modules
Summary of Contents for PPM3 MK2
Page 1: ...User Guide...
