PPM3 MKII Programmer - User Guide - V1.04 - 10
th
May 2008
65
4.7.2 Instructions
The instructions below detail how to set up the programmer to supply a controlled voltage to the
Target System.
1. Create a Programming Project which powers the Target System
•
In EQTools – Project Builder – Select the
<Target Power Supply Settings>
tab
•
Set the required
‘Target Voltage’
and
‘Tolerance’
eg. 3.3V +/- 500mV.
•
The
Voltage
‘Stabilise Time’
should be set to a long enough time to allow the voltage to reach
its final voltage (default: 200ms).
•
Under
the
‘Programmer Controlled Power Supply’
section,
select:
<Programmer controlled Target Power Supply: ON>
Æ
This enables the programmer to supply power to the Target System.
•
Enter the maximum current which your Target System could take from the programmer supply
(worst case i.e. current inrush condition)
•
Leave all other settings as the default values
Summary of Contents for PPM3 MK2
Page 1: ...User Guide...
