Using the Control Panel Menu
206
Heater Temperature
Pre-heater/platen heater:
30 °C to 50 °C
(86 °F to 122 °F)
After heater: 30 °C to 55 °C
(86 °F to 131 °F)
The temperatures for the pre-, platen, and after heaters can each be
adjusted separately.
Drying Time Per Pass
0 to 10sec
Select the time the print head pauses to allow drying after each pass.
Choose from values between 0.0 and 10.0 seconds. The time needed
for the ink to dry varies with ink density and the media used. If the
ink blurs on the media, set a longer time for drying the ink.
Increasing the drying time increases the time needed to print.
After Heater Feed
Mode 1
To feed media to the after heater after printing, choose
Mode 1
or
Mode 2
; otherwise, choose
Off
.
If
Mode 1
is selected, the portion fed for drying will not be rewound
before the next job starts. Select this option if the media will be cut
before the next job starts.
If
Mode 2
is selected, the portion fed for drying will be rewound
before the next job starts, eliminating unnecessary margin. Select
this option if multiple jobs will be printed consecutively.
Mode 2
Off
Additional Dryer
On
This item is displayed only when the additional print drying system
is installed (supplied with the S50675 and optional with other
models).
Select
On
to enable, or
Off
to disable, the optional additional print
drying system. Note that even when
On
is selected, the additional
print drying system will turn off with the heaters when the Heat Off
Timer expires. The additional print drying system will turn back on
when the heaters resume operation. See
“The Printer Setup Menu”
on page 208.
Off
Advanced Settings
During general use, use the default setting value without changing
it.
When using special media or when a problem such as head striking
or banding is detected in printing results, change the default.
Item
Parameter
Explanation
