Introduction
15
Inside - S70675 and S50675
Dirt on any of the following parts may reduce print quality. Regularly clean or exchange
these parts as described in the chapters listed in the reference sections below. The
illustration shows the S70675.
23 Media loading lever
After loading media, lower the media loading lever to keep the media in place. Raise the lever to release the media prior to
removal.
24 Alert lamp
This lamp lights or flashes when an error occurs.
On/flashing
: An error has occurred; the type of error is indicated by how the lamp lights or flashes. Check the message on
the control panel’s screen.
Off
: No error.
25 Control panel
See “Control Panel” on page 20.
26 Front cover
Open when loading media, cleaning the inside of the printer, or removing jammed media. Normally closed when using the
printer.
1
Print head
The print head prints by moving left and right while emitting ink. The print head on the left is Head 1, the print head on the
right Head 2. We recommend that you clean the area around this unit at the end of each workday.
See “Cleaning Around the Print Head (Daily)” on page 137.
2
Media holding plate (edge guide)
The media holding plates prevent the media riding up and keep fibers on the cut edge of the media from touching the print
head. Position the plates at either side of the media before printing.
See “Loading Media - S70675/S50675” on page 41 and “Loading Media - S30675” on page 65.