Basic Operations
123
Printable area - S70675/S50675
The printable area depends on whether low or high pressure rollers are used to set the
media.
Using Low Pressure Rollers
The gray area in the illustration below shows the printable area. The arrow indicates the
feed direction. The letter “A” indicates the pressure rollers on both edges when the
pressure rollers have been set correctly on the media.
The left and right edges of media recognized by the printer varies according to the Media Size Check settings.
Note:
If the setting is changed, the icon is displayed on the control panel screen as shown below.
To clear this icon, carry out the following operations.
❏
Re-execute Auto Media Adjust or Feed Adjustment.
❏
Execute Restore Settings.
On
The printer automatically detects the left and right edges of the loaded media.
When media holding plates are attached, within 5 mm (0.2 inches) of the left and right edges of the media is
recognized as the media edge.
The edges of the media are not detected correctly if the media holding plates are not attached correctly.
See “Using the standard media feeding unit” on page 41 or “Using the optional heavy roll media feeding unit”
on page 53
Off
: 5 mm (0.2 inches) at the exterior from “A” is recognized as the edge of the media.
If the pressure rollers are not positioned correctly, printing may occur outside the left and right edges of the
media.
Ink used outside the edges of the media will stain the inside of the printer.
See “Positioning the Pressure Rollers and Media (S70675, S50675)” on page 40.
