Emerson Rosemount 8732EM, Reference Manual

Page: 153 / 254

11.5.2 Replacing a terminal block socket module
Prerequisites
The terminal block socket module is shown in Figure 11-7 . To gain access to the socket
module, remove the junction box from the sensor adapter.
Socket Module—Terminal Block Figure 11-7:
A
A. Mounting screws:
• 2X—standard
• 4X—with I.S. divider
Removing a terminal block socket module
1. Disconnect power to the transmitter and the remote cabling connected to the
terminal block.
2. Remove the junction box cover to gain access to the remote cabling.
3. To disconnect the terminal block from the junction box housing, remove the two
mounting screws and the two divider mounting screws (if applicable).
4. Pull up on the terminal block to expose the socket module base.
5. To remove the socket module, loosen the two mounting screws and pull up on the
socket module from the base.
6. When removing the socket module, do not pull on the wires.
See Figure 11-5 .
Installing a terminal block socket module
1. Insert the new terminal block socket module, press the base into its keyed position,
and tighten the two mounting screws.
Maintenance
Reference manual 147