SEFELEC1500M Instructions
11
V1.06
1.3.
WARNING AND SAFETY INSTRUCTIONS
The SEFELEC1500M Megohmmeter & Pico-ammeter is designed to take measurements of
high-value resistances and of low-value currents.
Warning:
IMPORTANT
•
The measuring device must be used only in compliance with the provi-
sions mentioned hereinabove.
•
Correct usage of the measuring device assumes transport, installation,
handling and maintenance according to the instructions.
•
The admissible environmental conditions must also be complied with.
Safety instructions before use:
WARNING
•
Before using the measuring device, check the integrity of the power cord
and more particularly that the latter has not been subjected to any me-
chanical damage that can render a wire directly accessible and/or a con-
nection cut-off.
•
Before using the measuring device, check the integrity of the measuring
cords and more particularly that the latter have not been subjected to any
mechanical damage that can render a wire directly accessible and/or a
connection cut-off.
•
Before using the measuring device, check the connection of the latter with
a ground cable directly connected via the stud bolt at the rear of the
measuring device.
•
Before using the measuring device, check that none of the vents of the
measuring device are obstructed and that they allow air to flow freely.
•
Before using the measuring device, check that the connectors on the front
panel of the latter are nor damaged and/or not locked.
•
Use the ON/OFF push-button to turn the measuring device on and check
the lighting of the blue indicator light of the push-button on the front panel.
Safety instructions after use:
WARNING
•
After using the measuring device, before any action on the measuring de-
vice, check that the red indicator light is not lit and the lighting of the green
indicator light on the front panel of the measuring device.
•
Use the ON/OFF push-button to turn the measuring device off and check
that the blue indicator light of the push-button is not lit on the front panel of
the measuring device.
•
Disconnect the tested product.