9711-26020-0001
Exp o rt Co n tro lle d – S e e P a g e 3
Rev D
SECTION 7
MAINTAINING YOUR ARMOR X10GX
Page 177 of 234
ARMOR X10gx Tablet Computer
9.
Reinstall the batteries and reconnect
external power if desired.
Re m o vin g a n d Re p la c in g a Me m o ry Mo d u le
Two 2GB memory modules are located in a sealed compartment at the lower left rear corner of
the tablet, as indicated in Figure 4. Follow the procedure in Table 24 to replace a module.
NOTE
This procedure should only be performed by a qualified
technician in a controlled environment.
CAUTION!
These modules contain electrostatic discharge (ESD) sensitive
devices. Static-free handling and processing is required to
prevent possible damage to the components.
Table 24. Replacing a Memory Module
STEP
ACTION
condition or indication
1.
Power down the tablet, remove the
batteries and disconnect any external
power.
2.
Place the tablet face down on a clean
surface and remove the 10 Philips screws
securing the hard drive cover, then
remove the cover to expose the memory
modules, as shown in Figure 106.
