Dinolift DINO 260XT, Operating Instructions Manual

Page: 21 / 101

DINO 260XT
21
4. To access the operating controls open the cover on the chassis
Check the condition of the battery to ensure
operation of the emergency descent system.
The charge level of the battery is indicated by
LEDs.
During charging the red LED is on and the green
LED is off.
-
when the battery is almost fully charged, both
LEDs are lit
-
when the battery is fully charged, the green
LED is lit and the red one flashes
-
if both LEDs are lit after full charging, the
battery is dead
5. Turn the selector switch (1) to position 1 (page 22)
6. Start the engine with button 2 (green)
-
turn off the choke (combustion engine use)
- adjust the engine speed (combustion engine)
7. Lower the front support outriggers (on the tow-bar side)
8. Lower the rear support outriggers (do not damage the tow-bar jockey wheel)
9. Level the chassis with the outriggers with the help of the level gauge (16) (page 22)
MAKE SURE THAT THE WHEELS ARE CLEARLY OFF THE GROUND
-
the signal light 4A on the chassis control panel is lit when all outriggers are in the lower position and
the outrigger limit switch circuit is connected
-
make sure all outriggers are firmly supported on the ground