Dinolift DINO 260XT, Operating Instructions Manual

Page: 61 / 101

DINO 260XT
61
-
check the condition of the telescope cylinder bearings and pins and the
locking of the pins
Check the condition of the gas springs
-
check the condition of the master and slave cylinder bearings and pins and
the locking of the pins
-
check the condition of the boom joint
-
check the bearing and the pin of the boom joint and the locking of the pin
-
check the condition and attachment of the articulated arm joint pins and
bearings
-
check the support outriggers and their footplates
-
check the mechanical structure of the outriggers and the welded seams
The structures must not show signs of deformations or cracks No fractures or
cracks allowed in the welded seams.
-
check the footplates for deformations, cracks or breaches
Also check that the footplate can turn freely on its joint.
-
inspect the boom.
-
extend the telescope and check that there are no permanent deformations,
dents or traces of substantial wear in the boom
-
also check the welded seams for wear, cracks or breaches
-
check the boom attachment for cracks or breaches
-
check the condition of the platform brackets
-
check the locking of the platform pin
-
check the condition and attachment of the flyer-chain, the locking of the pins
and the tightness of the spring
-
check the condition of the cable chain, its clamp brackets as well as the
tightness of the screw connections
-
check the play and attachment of the gliding surfaces on the boom.
-
inspect the platform
-
general condition
-
check that the platform does not show signs of deformations, substantial wear
or buckles
-
check that the handrails, the steps, the gate and the attachment of the gate are
in order
-
check that the lock of the gate and the gas spring are in order
-
check the condition of the platform floor plate
-
check the platform carrier for notable buckles or deformations
-
check all protective covers
-
check the condition of the support outrigger cylinder guards
-
check the condition of the slave cylinder guard
-
check the condition of the boom end cover, turning device covers, chassis
control panel cover, safety device cover, platform control panel cover and the
rear light cover
-
perform visual inspection of all screw connections
-
inspect the turning device
-
general condition
-
check the play and attachment of the angular gear
-
check the condition of the gear ring