Dinolift DINO 260XT, Operating Instructions Manual

Page: 26 / 101

DINO 260XT
26
12. Test the operation of the overload limit switch RK4
-
put a load of about 80 kg onto the platform
-
drive the boom to a horizontal position
-
extend the telescope
As the movement stops the red overload light (18) must light up.
-
compare the outreach with the set values given on page 6 of this manual (the distance to the outer face
of the platform = outreach - 0,5 metres)
12A. Measures to be taken after overloading has occurred
-
(The overload limit switch RK5 switches off the electric circuit of the operating controls and
switches on the buzzer on the platform)
-
retract the platform to inside the operating range of the RK4 by pushing the ”telescope in” -
button (31 or 36) (the green light lights up)
-
after this the lift may be operated normally
Telescope in - pushbutton (31 or 36) is always operational when the electric motor is running or the
emergency descent button (5 tai 20) is depressed.
WARNING!
Do not add load (e.g. another person) onto the platform while the red overload light (18) is lit. Example:
A person, who is working alone on the platform, extends the telescope, or an empty platform is driven
from the chassis control panel to the maximum reach keeping it close to the ground. If the overload signal
light now lights up, the telescope must be retracted before loading the platform further.
IF THE SAFETY DEVICES OR THE EMERGENCY DESCENT SYSTEM ARE NOT
WORKING, HAVE THEM REPAIRED BEFORE OPERATING THE LIFT!
13. Refer to the item "Daily inspections" in the task list for servicing
14. With the boom slightly lifted and the telescope extended, make sure that the platform does not
lower of itself while the operating controls are not being used
15. When working under cold weather conditions, let the engine run for a while without load to
increase the hydraulic oil temperature. Start the operations by driving the movements carefully
without load back and forth from the chassis control panel.