Dinolift DINO 260XT, Operating Instructions Manual

Page: 68 / 101

DINO 260XT
68
FAULT REMEDY
17. Too low braking force
Too much play in the brake system.
Adjust the brakes (refer to page 37).
Brake linings not yet run-in. Pull the parking brake lever slightly and drive 2 -
3 kilometres.
Brake-shoes "glazed", dirty or oil on the friction
surfaces. Replace the brake-shoe sets.
Clean the friction surfaces of the brake drum.
Overrun brake jams. Lubricate.
Brake rod jammed or bent. Repair.
Brake wires rusty or broken. Replace wires.
18. Braking uneven and jerky
Too much play in the brake system.
Adjust the brakes (refer to page 37).
Shock absorber of the overrun device faulty. Replace the shock absorber.
Reverse automatics - brake-shoe jams in the
carrier.
Replace the brake-shoe in the carrier.
19. The brakes drag (only one of the wheels brakes)
Brake units wrongly adjusted.
Readjust the brake units according to
instructions.
Also refer to point 17 for possible cause.
20. Lift brakes as the engine speed is decreased
Shock absorber of the overrun device faulty.
Replace the shock absorber.
21. Reversing forced or impossible
Brakes have been adjusted too tight.
Adjust the brake system as instructed on page 37.
22. Wheel brakes overheat
Brake system wrongly adjusted.
Adjust the brake system as instructed on page 37.
Wheel brakes dirty. Clean the wheel brakes.
Overrun brake - force transmission lever jams. Dismantle, clean and lubricate the transmission
rod.
Parking brake not completely released. Release the parking brake completely.