Dinolift DINO 260XT, Operating Instructions Manual, Page: 45 / 101

DINO 260XT
45
REGULAR SERVICING
The lift shall be serviced regularly at intervals of 11 - 12 month.
Under demanding conditions where moist, corrosive substances or corrosive climate may speed up the
deterioration of the structure and induce malfunctions, the inspection must be performed more often and
the influence of corrosion and malfunctions must be reduced by using appropriate protective means.
Only technical specialists who are familiar with the structure and the operation of the lift are allowed to
maintain the lift.
We recommend turning to the service staff of the dealer.
SCHEDULE FOR REGULAR SERVICING
1. Clean the lift thoroughly before the service
The hydraulic and electric appliances must not be dismantled if they are not clean. Any contaminants in
the system may cause malfunctions later on.
Wash the lift externally.
ATTENTION!
Be careful not to direct the high pressure water jet straight to the electric appliances, such as the control
panels on the chassis and on the platform, relays, solenoid valves and limit switches.
-
use pressure air to dry the electric devices, hydraulic connectors etc.before opening them
- apply appropriate moisture repellent to the electric appliances after the drying
- always protect the piston rods with e.g. CRC3-36 anti-corrosive agent after washing with a solvent
REMEMBER CLEANLINESS!
2. Change the hydraulic oil and replace the filter
(protect your skin against the hydraulic oil)
-
remove the plug and drain the oil tank with the cylinders of the lift completely retracted
- clean and rinse the oil tank with suitable agent
-
replace the pressure and return filters
- install the drain plug
- refill the tank with fresh oil, the oil volume required for change is 30 l
Factory filling Neste Hydrauli 28 Super or Esso Univis J26 or environmentally friendly Raisio Biosafe
Hydraulic oil 32 NE.
-
never mix different oil sorts
- if required, top up hydraulic oil to the level with the upper edge of the level eye while the lift is in the
transport position.