Dinolift DINO 260XT, Operating Instructions Manual

Page: 55 / 101

DINO 260XT
55
13. Warning signs and adhesives
-
make sure that all warning signs and adhesives are legible, replace if necessary
14. Inspect the brakes and the driving device
-
remove the wheels
-
clean the brake system and check the settings
-
check the free movement of the brake shoes the operation of their return springs
-
replace any worn out linings
-
check the condition of the driving device and lubricate the joints
-
put the wheels in place and tighten the wheel bolts (325 Nm)
Remember to re-check the tightness after about 100 km drive.
-
check the tyre pressure: 700 kPa (4.5 bar) on the rear axle
250 kPa (2.5 bar) on the jockey wheel
-
check the free movement of the overrun brake and the parking brake
-
check the safety wires
15. Check the condition of the lights and the reflectors
16. Repeat the anti-corrosion treatment using e.g. Tectyl 210R anti-corrosion agent
17. Test-run with a load of 80 kg following the loading instructions
Check the structures after the test-run
18. Draw up a test protocol, save your own copy and give the other copy to the customer