Dinolift DINO 260XT, Operating Instructions Manual

Page: 53 / 101

DINO 260XT
53
Adjustment method I:
-
make sure that the RK5 with certainty will trip before the RK4 by adjusting the RK4
- extend the boom and measure the length of one protruding part of the telescope extension (stroke)
- the measure shall be 2,350 mm ±50 mm.
- tighten the locking of the adjustment screw and check once more the settings
- set RK4 to trip earlier than RK5
- extend the boom and measure the stroke
- the measure shall be 2,050 mm ±50 mm.
- tighten the lock nut of the adjustment screw and check once more the settings.
- apply a safety wire to the adjustment screws in such a manner that it will not be possible to unscrew
the screws away from the limit switches
-
apply a seal on the wire
- the gap between the adjustment screw and the tip of
the limit switch RK4 shall be 1 - 3 mm
- put the cover in place
The 2nd alternative for securing the RK5 when the securing wire is in place is described in this manual