Dinolift DINO 260XT, Operating Instructions Manual

Page: 30 / 101

DINO 260XT
30
DRIVING DEVICE
The hydraulic driving device is intended for moving the lift within the work area if the towing vehicle
cannot be used.
-
start the aggregate and adjust the engine speed to ¾ of the maximum (petrol engine).
The running speed of the aggregate affects the driving speed.
- turn the selector switch (1) to position "support outriggers" (page 22)
- make sure that the platform is in the transport position and the outriggers are in the upper position
- make sure that the mains cable is long enough to cover the whole travel distance (power supply from
mains)
- press the driving device against the wheel (lever 6 to the left)
-
release the parking brake
- use the buttons 28L and 28R and the lever switch 28 (page 22) for driving:
forward lever switch 28 to the right
backward lever switch 28 to the left
forward to the left pushbutton 28L + lever switch 28 to the right
forward to the right pushbutton 28R + lever switch 28 to the right
backward to the left pushbutton 28L + lever switch 28 to the left
backward to the right pushbutton 28R + lever switch 28 to the left
- do not drive the jockey wheel into obstacles or potholes
- after the driving apply the parking brake
-
disconnect the driving device from the wheel using the switch 6 (to the right)
Remote control of the driving device (optional extra).
-
plug in the remote control cable to the socket in the driving device control box
ATTENTION!
Be careful not to damage the jockey wheel tube by extending it too much. As the lift is moved with the
driving device, the suitable length for the jockey wheel stem can be achieved by adjusting the gap
between the lower surface of the tow-bar/brake rod and the wheel to 1 - 3 cm. Thus the wheel can turn
freely.