Dinolift DINO 260XT, Operating Instructions Manual

Page: 19 / 101

DINO 260XT
19
START-UP
1. Ground stability
-
make sure that the ground is even and hard enough to support the lift in a steady level position
Soil material Density Max. ground
pressure
P kg/cm²
Gravel High density 6
Medium density 4
Loose 2
Sand High density 5
Medium density 3
Loose 1,5
Fine sand High density 4
Medium density 2
Loose 1
Sand/ mud High density (very hard to work) 1,00
Medium density (hard to work) 0,50
Loose (easily worked) 0,25
-
if the ground is soft, use sufficiently large and sturdy additional plates under the support outriggers
-
observe the effect of ice, possible rain and inclination of the surface on the support (the support
outriggers must not slip on the surface)
-
the operation is prohibited if the lift is not properly supported and in a level position
2. Drive or push the lift to the inspected lifting site
-
apply the parking brake
-
disconnect the lift from the towing vehicle