58
www.digiop.com
SECTION 5: CONFIGURE COUNTING LINES
5.
Click
Save
.
5.14.3 Verifying Filter Zone placement
You should use the Start Stop Map to verify the placement of Filter zones. Filter zones allow you to define the area that tracks must
start or end in to be counted as an enter or an exit. The Start Stop Map allows you to see exactly where tracks start and end so that
you can place the filter in the correct location.
Complete the following steps to verify Filter Zone placement:
1.
Clear the maps by resetting the camera, then run the camera for 4-6 hours.
2.
Access the Counting tab and select Start Stop Map from the drop-down box. The Start Stop Map appears in the right image
space.
Counting page with Start Stop map
3.
Verify that all starts and stops are included in the desired filter zone and that the enter/exit lines have not been drawn too
close to the start and stop points.
4.
Click
Save
.
