31
DIGIOP® 3D Camera User Manual
SECTION 3: CONFIGURE THE DIGIOP® 3D CAMERA
12. Click the Aggregation Level drop-down list. Select the frequency at which the metric data will be stored in the files. The
camera can store data in intervals of 5, 15, 30, and 60 minutes.
13. Click the
Delivery Format
drop-down and select the format for the data files sent over FTP. There are two options,
Pipe
Delimited
and
XML
.
Pipe Delimited Format
: The Pipe Delimited format sends data for each report zone with the relevant information
separated by a pipe character “|”.
XML Format
: The XML format sends metric data in an XML file similar to the XML packets that are sent out using the Batch
Data Streaming option. See the DIGIOP® 3D camera Programmer Guide for more information on the XML format.
14. Click the
Delivery Schedule
drop-down box and select the frequency at which the FTP file is delivered. You can have an
FTP file delivered each hour or you can have the file delivered once daily at a scheduled time.
15. If you selected
Daily
in the previous step, enter a delivery time in the
Delivery Time
field. The Delivery Time should be
entered in 24 hour notation (00:00-23:59).
16. In the Maximum Retries field, enter the maximum number of times the camera should attempt to reconnect to the FTP
server to send the files when a failure occurs. If the Maximum Retries field is set to zero, the camera will continue to retry
indefinitely until it successfully sends the file.
17. In the Retry Interval field, enter the length of time, in seconds, the camera will wait before attempting to reconnect to the
FTP server. This value can range from 1 to 599 seconds.
18. Select the
Port Range
check box if you are using an active FTP server and want to limit the port range that is used for
connections. Enter the port range into the
Lowest Port
field and the
Highest Port
field.
19. If you want to pass an IP address to your firewall that is different from the DIGIOP® 3D camera IP address and FTP server,
select the
External IP Override
checkbox, then enter the IP address.
20. Click
Test FTP Settings
to verify that the camera can connect to the FTP server.
NOTE
This test does not verify that a file can be transferred to the server. It only verifies that the camera can log in to an FTP server
at the specified IP address and port number using the username and password specified.
You may encounter the following errors when configuring the FTP delivery options:
—
Failed to connect 36
: Incorrect Server IP Address
—
Failed to connect 64
: Incorrect Port Number
—
Failed to connect 530 password not accepted
: Incorrect Username and/or Password
21. Click
Save
to save the current settings
