Interfaces
Wide Area Networks (WANs)
Digi Connect EZ Mini User Guide
59
(config network interface my_wan ipv4 surelink)> timeout
value
(config network interface my_wan ipv4 surelink>
where
value
is any number of weeks, days, hours, minutes, or seconds, and takes the
format
number
{
w|d|h|m|s
}.
For example, to set
timeout
to ten minutes, enter either
10m
or
600s
:
(config network interface my_wan ipv4 surelink)> timeout 600s
(config network interface my_wan ipv4 surelink)>
The default is 15 seconds.
8. (Optional) Repeat this procedure for IPv6.
9. Save the configuration and apply the change:
(config network interface my_wan ipv4 surelink)> save
Configuration saved.
>
10. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configure the device to reboot when a failure is detected
Using SureLink, you can configure the Connect EZ device to reboot when it has determined that an
interface has failed.
Required configuration items
n
Enable SureLink.SureLink can be enabled for both IPv4 and IPv6 configurations. By default,
SureLink is enabled for IPv4 for the preconfigured WAN. It is disabled for IPv6.
n
Enable device reboot upon interface failure.
n
The type of probe test to be performed, either:
l
Ping: Requires the hostname or IP address of the host to be pinged.
l
DNS query: You can perform a DNS query to a named DNS server, or to the DNS servers
configured for the WAN.
l
HTTP or HTTPS test: Requires the URL of the host to be tested.
l
Interface status: Determines if the interface has an IP address assigned to it, that the
physical link is up, and that a route is present to send traffic out of the network interface.
Additional configuration items
n
See for
Configure SureLink active recovery to detect WAN failures
optional SureLink
configuration parameters.
