Interfaces
Wide Area Networks (WANs)
Digi Connect EZ Mini User Guide
58
7. Optional active recovery configuration parameters:
a. Move back two levels in the configuration by typing
.. ..
:
(config network interface my_wan ipv4 surelink target 0)> .. ..
(config network interface my_wan ipv4 surelink>
b. To configure the device to restart the interface when its connection is considered to have
failed:
(config network interface my_wan ipv4 surelink)> restart enable
(config network interface my_wan ipv4 surelink>
This is useful for interfaces that may regain connectivity after restarting.
c. To configure the device to reboot when the interface is considered to have failed:
(config network interface my_wan ipv4 surelink)> reboot enable
(config network interface my_wan ipv4 surelink>
Note
If both the
restart
and
reboot
parameters are enabled, the
reboot
parameter takes
precedence.
d. Set the
Interval
between connectivity tests:
(config network interface my_wan ipv4 surelink)> interval
value
(config network interface my_wan ipv4 surelink>
where
value
is any number of weeks, days, hours, minutes, or seconds, and takes the
format
number
{
w|d|h|m|s
}.
For example, to set
interval
to ten minutes, enter either
10m
or
600s
:
(config network interface my_wan ipv4 surelink)> interval 600s
(config network interface my_wan ipv4 surelink)>
The default is 15 minutes.
e. If more than one test target is configured, determine whether the interface should fail over
based on the failure of one of the test targets, or all of the test targets:
(config network interface my_wan ipv4 surelink)> success_condition
value
(config network interface my_wan ipv4 surelink>
Where
value
is either
one
or
all
.
f. Set the number of probe attempts before the WAN is considered to have failed:
(config network interface my_wan ipv4 surelink)> attempts
num
(config network interface my_wan ipv4 surelink>
The default is
3
.
g. Set the amount of time that the device should wait for a response to a probe attempt
before considering it to have failed:
