Services
Configure a multicast route
Digi Connect EZ Mini User Guide
341
2. Use the
command at the system prompt:
> show ntp
NTP Status Status
-----------------
Status
: Up
Sync Status : Up
Remote
Refid
ST
T
When
Poll
Reach
Delay
Offset
Jitter
----------------
-------------
--
-
----
----
-----
------
-----
-
------
*ec2-52-2-40-158
129.6.15.32
2
u
191
1024
377
33.570
+1.561
0.991
128.136.167.120
128.227.205.3
3
u
153
1024
1
43.583
-
1.895
0.382
>
3. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configure a multicast route
Multicast routing allows a device to transmit data to a single multicast address, which is then
distributed to a group of devices that are configured to be members of that group.
To configure a multicast route:
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click
System
. Under
Configuration
, click
Device Configuration
.
The
Configuration
window is displayed.
3. Click
Services
>
Multicast
.
4. For
Add Multicast route
, type a name for the route and click
.
5. The new route is enabled by default. To disable, uncheck
Enable
.
6. Type the
Source address
for the route. This must be a multicast IP address between 224.0.0.1
and 239.255.255.255.
7. Select a
Source interface
where multicast packets will arrive.
8. To add one or more destination interface that the Connect EZ device will send mutlicast
packets to:
