Delta AX-3 Series, Operation Manual

Page: 247 / 370

C h a p t e r 7 M o t i o n C o n t r o l B a s i c S e t t i n g s & O p e r a t i o n
7 - 1 2 9
7_

Software display
Can be configured via DIADesigner-AX software.
The positive and negative position are able to be resized on the configuration page:
Item Data Type Default Setting
Negative LRAEL 0.0
Position LRAEL 10000.0
7.7.8.3 Position Lag Setting
The command position as well as feedback position are located at zero while the axis is in motion. If there’s a
greart difference between command position and feedback position, an error will be reported.
The position lag reaction is set to be “Stay Enabled” as default.
Setting mode Function
Deactivated Not activated.
Disable drive When position lag exceeds limit setting, axis will shift to servo off.
Do quickstop When position lag exceeds limit setting, axis will shift to quick stop.
Stay enabled When position lag exceeds limit setting, axis will remain as servo on.