Dell Precision WorkStation 210, User Manual

Page: 3 / 247

v
6DIHW\,QVWUXFWLRQV
Use the following safety guidelines to help protect your computer system from
potential damage and to ensure your own personal safety.
:KHQ8VLQJ<RXU&RPSXWHU6\VWHP
As you use your computer system, observe the following safety guidelines.
:$51,1*'RQRWRSHUDWH\RXUFRPSXWHUV\VWHPZLWKDQ\FRYHUV
LQFOXGLQJFRPSXWHUFRYHUVEH]HOVILOOHUEUDFNHWVIURQWSDQHOLQVHUWV
DQGVRRQUHPRYHG
‡
To help avoid damaging your computer, be sure the voltage selection switch on
the power supply is set to match the AC power available at your location:
— 115 volts (V)/60 hertz (Hz) in most of North and South America and some
Far Eastern countries such as South Korea and Taiwan
— 100 V/50 Hz in eastern Japan and 100 V/ 60 Hz in western Japan
— 230 V/50 Hz in most of Europe, the Middle East, and the Far East
Also be sure your monitor and attached peripherals are electrically rated to
operate with the AC power available in your location.
‡
Before working inside the computer, unplug the system to help prevent electric
shock or system board damage. Certain system board components continue to
receive power any time the computer is connected to AC power.
‡
To help avoid possible damage to the system board, wait 10 to 20 seconds after
disconnecting the system from AC power (until the standby light-emitting diode
[LED] on the system board goes out) before removing a component from the
system board or disconnecting a peripheral device from the computer.
‡
To help prevent electric shock, plug the computer and peripheral power cables
into properly grounded power sources. These cables are equipped with
three-prong plugs to help ensure proper grounding. Do not use adapter plugs or
remove the grounding prong from a cable. If you must use an extension cable,
use a three-wire cable with properly grounded plugs.