Dell Precision WorkStation 210, User Manual

Page: 143 / 247

Installing Drives 9-7
)LJXUH5HPRYLQJD'ULYH
If a drive is already installed in the bay and you are replacing it, be sure to
disconnect the DC power cable and interface cable from the back of the drive
before sliding the bracket out of the bay. To remove the old drive from the
bracket, turn the drive/bracket assembly upside down and unscrew the four
screws that secure the drive to the bracket (see Figure 9-7).
5. Attach the bracket to the new drive.
Turn the drive upside down and locate the four screw holes around its perimeter.
Fit the bracket over the drive, and then tilt the front of the drive up so that the
bracket drops down into place. To ensure proper installation, all screw holes
should be aligned and the tabs on the front of the bracket should be flush with
the front of the drive (see Figure 9-7).
)LJXUH$WWDFKLQJWKH'ULYH%UDFNHWWRWKH1HZ'ULYH
bracket tabs (2)
bracket
bracket tabs (2)