Dell Precision WorkStation 210, User Manual

Page: 198 / 247

D-8 Dell Precision WorkStation 210 Mini Tower Systems User’s Guide
Each Dell system, when operating, is designed to withstand 0.25 G (half-sine wave) at
a sweep of 3 to 200 hertz (Hz) for 30 minutes. In storage, the system can withstand
0.5 G at 3 to 200 Hz for 30 minutes.
3RZHU6RXUFH,QWHUUXSWLRQV
Systems are especially sensitive to variations in voltage supplied by the AC power
source. Over-voltage, undervoltage, and transients (or
spikes
) can erase data from
memory or even cause components to fail. To protect against these types of
problems, power cables should always be properly grounded and one or both of
the following methods should be used:
‡
Use one of the power protection devices described in the following section,
“Power Protection Devices.”
‡
Place the system on a dedicated power circuit (rather than sharing a circuit with
other heavy electrical equipment). In general, do not allow the system to share a
circuit with any of the following:
— Copier machines
— Air conditioners
— Vacuum cleaners
— Space heaters
— Power tools
— Teletype machines
— Adding machines
— Laser printers
— Facsimile machines
— Any other motorized equipment
Besides these appliances, the greatest threats to a system’s supply of power are
surges or blackouts caused by electrical storms. Whenever possible, turn off the
system and any peripherals and unplug them from their power sources during
thunderstorms.
If a blackout occurs—even a temporary one—while the system is turned on, turn off
the system immediately and disconnect it from the electrical outlet. Leaving the
system on may cause problems when the power is restored; all other appliances left
on in the area can create large voltage spikes that can damage the system.
3RZHU3URWHFWLRQ'HYLFHV
A number of devices are available that protect against power problems such as power
surges, transients, and power failures. The following subsections describe some of
these devices.