Dell Precision WorkStation 210, User Manual

Page: 132 / 247

8-12 Dell Precision WorkStation 210 Mini Tower Systems User’s Guide
8. Replace the computer cover, and reconnect your computer and peripherals to
their power sources and turn them on.
As the system boots, it detects the presence of the new processor and
automatically changes the system configuration information in the System
Setup program.
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
9. Enter the System Setup program, and confirm that the system data area correctly
identifies the type and number of installed processor(s).
See Chapter 3, “Using the System Setup Program.”
10. While in the System Setup program, reset the chassis intrusion detector by
changing Chassis Intrusion to Not Detected .
See Chapter 3, “Using the System Setup Program,” for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
11. If you installed a second microprocessor and your system is running
Windows NT 4.0, you must reinstall the operating system to load the Windows
NT Multi-Processor kernel.
See your Windows NT documentation for instructions.
When you reinstall Windows NT 4.0, the operating system detects the second
microprocessor.
12. Run the Dell Diagnostics to verify that the new microprocessor is operating
correctly.
See your
Diagnostics and Troubleshooting Guide
for information on running the
diagnostics and troubleshooting any problems that may occur.
5HSODFLQJWKH6\VWHP%DWWHU\
A 3.0-V CR2032 coin-cell battery installed on the system board maintains system
configuration, date, and time information in a special section of memory.