Dekema AUSTROMAT 624, Operating Instructions Manual

Page: 59 / 155

AUSTROMAT
®
624 / 644 5. User interface
Operating Instructions (Version 01/2012) 59
5.5. Program sequence
A firing program is started from the Program Display by pressing [Program Start]. Please note:
• The preheating of the firing furnace depends on the last selected program type.
•
Easy, professional and pressing programs (only 644 ):
The firing furnace automatically heats to the required preheating temperature (drying or
start temperature). You can terminate this process by pressing the [ON/OFF] key,
•
Classic programs:
The firing furnace automatically heats to the preheating temperature of the last
selected easy, professional, or pressing program (i.e., before the classic program was
selected) (only the
644 ).
All the parameters that are still open after the program has ended remain active after
the program is over. They only loose their validity when the firing furnace is switched to
wait mode by pressing the [ON/OFF] key, or when they are deactivated or replaced
with new parameters (such as program procedure),
• The program steps are executed in the specified sequence in the input mask (see section
5.4),
• Select [Cancel program] to prematurely terminate a running program. In this case, all the
commands are stopped and the heat system is turned off. The firing furnace cools down.
The firing number is not increased during firing.
Fig. 5-12 Example of the sequence of a pressing program (644 as an example)
The example of Fig. 5-12 ( 644 pressing furnace) generates the following firing program:
Step 0:
[Start Program] Program started with an open firing chamber (mounted muffle).