Dekema AUSTROMAT 624, Operating Instructions Manual

Page: 111 / 155

AUSTROMAT
®
624 / 644 6. Operation
Operating Instructions (Version 01/2012) 111
6.4. Program end
While the program is running, you can stop the program by clicking [Cancel program]. In this
case, all the commands are stopped and the heat system is turned off. The firing furnace cools
down. The firing number is not increased during firing.
The behavior of the firing furnace after a regular program end depends on the type of program
that was run:
• Easy, professional and pressing programs (only the 644 pressing furnace) have a specific
fixed program structure.
•
An acoustic signal sounds after a regular program end,
•
The lift moves down,
• The firing number is automatically increased,
•
A log file for the firing is created and printed (if a printer is configured).
•
Classic programs are freely programmable. The firing furnace only executes the commands
that are in the program.
•
An acoustic signal sounds after a regular program end,
• The firing number is automatically increased,
•
A log file for the firing is created and printed (if a printer is configured).
You can remove the firing object after the program is over (see section 6.2).
NOTE:
If, after the firing program is over, the firing chamber is opened longer than 15 minutes
while the chamber temperature is above 200°C, a message appears and asks you to
close the firing chamber to prevent wear.
•
Acknowledge the message.
•
Close the firing chamber.