4.
Refer to Figure 3–2 to install the CD–ROM drive into the mass storage
slot:
p
Using the tabs in front of the upper and lower finger cutouts, firmly
push the drive brackets until the interface card at the rear of the drive
plugs into its backplane connector (A).
5.
Tighten the captive screws at the top and bottom of the bracket (A).
CAUTION
It is normal for there to be a small gap between the mounting bracket
guide tabs and the enclosure frame. Tighten the captive screw only
until it is securely fastened (9 inch pounds). Do not try to force the
tabs to fit flush against the frame.
6.
Attach the ISE front panel to the enclosure by first fitting the panel’s lower
tabs into position.
p
Fit the panel into position and secure the panel with its single captive
Phillips screw (B).
7.
If you do not have a KZQSA installed, go to Section 3.4 to complete the
installation.
If you do have a KZQSA installed, continue with the next step.
3–4 RRD-Series CD–ROM Drive
