3.3 Installation Procedure
Use the following procedure to install the RRD-series CD–ROM drives into the
BA400-series enclosure. Have the system manager shut down the operating
system before installing the CD–ROM drive.
CAUTION
Static electricity can damage integrated circuits. Use the antistatic
wrist strap and antistatic pad found in the static-protective field service
kit (29-26246-00) when you work with the internal parts of a computer
system.
1.
Open the top and bottom enclosure doors.
2.
Power off the system and unplug the power cord from the wall outlet.
3.
Loosen the captive Phillips screw (at the top) and remove the front panel
from the first available storage slot.
Note
The first mass storage cavity in the mass storage area (slot 0) is wider
than the rest to accommodate a large device, such as a tape drive.
A small filler panel (70-27414-01) is used to fill the gap when an
RRD-series ISE is installed in this first cavity.
3–2 RRD-Series CD–ROM Drive
