4.
With the tape drive left side down (LEDs at the bottom), slide the drive
into mass storage slot 0.
p
Using the tabs in front of the upper and lower finger cutouts, firmly
push the drive bracket into the enclosure until the interface card at the
rear of the drive plugs into its backplane connector.
5.
Refer to Figure 2–2 to complete the drive installation.
a.
Tighten the captive screws at the top and bottom of the bracket (1).
CAUTION
It is normal for there to be a small gap between the mounting bracket
tabs and the enclosure frame. Tighten the captive screw only until it
is securely fastened (9 inch pounds). Do not try to force the tabs to fit
flush against the frame.
b.
Attach the drive front panel to the enclosure by first fitting the panel’s
lower tabs into position (2).
c.
Secure the front panel with its single captive Phillips screw (3).
TLZ-Series Tape Drives 2–5
