Data Flow Systems TCU800, Installation And Operation Manual

Page: 64 / 162

54
C h a p t e r 6
Station The number assigned to the pump station.
Data Invert
Data Invert and Data Swap are used to prevent cross-talk from other DFS radio
systems on the same frequency. Although uncommon, atmospheric conditions can
occur that allow low power transmitters to ‘skip’ and reach distances much farther
than designed. Inverting or swapping the data on one of the radio systems will prevent
the two systems from communicating with each other. A value of ‘0’ indicates it is
disabled. A value of ‘1’ indicates it is enabled.
Data Swap
Tx Invert
TX Invert is available to accommodate the serial interface requirements of the
radio the TCU is connected to. A value of ‘0’ indicates it is disabled. A value of ‘1’
indicates it is enabled.
Rx Invert
RX Invert is available to accommodate the serial interface requirements of the
radio the TCU is connected to. A value of ‘0’ indicates it is disabled. A value of ‘1’
indicates it is enabled.
Async Baud
The communication baud rate on the radio. Current config options are ‘0’ for legacy
radio or 9600 for high-speed serial radio.
Dash Number
The dash number is assigned to indicate the model and mode of the radio installed
in the unit.
GBL MOD DLY
Global Module Delay. The Global Delay settings are automatically assigned based
on the model and mode of the radio installed. These are fixed and cannot be adjusted.
GBL FIX DLY
Fixed Offset Delay Timer. The Global Delay settings are automatically assigned
based on the model and mode of the radio installed. These are fixed and cannot be
adjusted.
GBL STA DLY
Global Station Delay. The Global Delay settings are automatically assigned based on
the model and mode of the radio installed. These are fixed and cannot be adjusted.
RAD PGM
The Radio Program indicates the frequency to which the radio has been configured.