5-35 Off Delay, Digital Output
Default value: 0.01 s
Parameter type: Range
2-setup: All setups
Conversion index: -2
Data type: u_int16
Change during operation: True
Enter the delay time before the digital output is switched off. The digital output (terminal 42/45) condition must not be interrupted
during the delay time.
Table 141: Range:
Min: 0 s
Max: 600 s
Default value: 0.01 s
4.7.4 5-4* Relays
Parameters for configuring the timing and the output functions for the relays.
5-40 Function Relay
Default value: [0] No operation
Parameter type: Option
2-setup: All setups
Conversion index: -
Data type: u_int8
Change during operation: True
Select options to define the function of the relays.
Table 142: Option:
[0]
No operation
No operation.
[1]
Control Ready
The control board receives supply voltage.
[2]
Drive ready
The drive is ready for operation and applies a supply signal on the control board.
[3]
Drive ready/remote
control
The drive is ready for operation in auto-on mode.
[4]
Standby/no warning
The drive is ready for operation. No start or stop command is given. No warnings are present.
[5]
Drive running
The motor runs.
[6]
Running/no warning
The motor runs, and no warnings are present.
[7]
Run in range/no
warning
The motor runs within the programmed current ranges, see
parameter 4-50 Warning Current Low
and
parameter 4-51 Warning Current High
. No warnings are present.
[8]
Run on ref/no warn-
ing
The motor runs at reference speed and with no warnings.
[9]
Alarm
An alarm activates output.
[10]
Alarm or warning
An alarm or warning activates output.
[12]
Out of current range
The motor current is outside the ranges set in
parameter 4-50 Warning Current Low
and
parame-
ter 4-51 Warning Current High
.
[13]
Below current, low
The motor current is lower than the limit set in
parameter 4-50 Warning Current Low
.
[14]
Above current, high
The motor current is higher than the limit set in
parameter 4-51 Warning Current High
.
[16]
Below speed, low
The drive output speed is lower than the limit set in
parameter 4-40 Warning Freq. Low
.
[17]
Above speed, high
The drive output speed is higher than the limit set in
parameter 4-41 Warning Freq. High
.
[19]
Below feedback, low
The feedback is lower than the limit set in
parameter 4-56 Warning Feedback Low
.
[20]
Above feedback, high
The feedback is higher than the limit set in
parameter 4-57 Warning Feedback High
.
AU363928304090en-000101 / 130R0982
86 | Danfoss A/S © 2021.07
Parameters
VLT® Flow Drive FC 111
Programming Guide
