16-16 Torque [Nm]
Default value: 0 Nm
Parameter type: Range
2-setup: All setups
Conversion index: -1
Data type: int32
Change during operation: False
View the torque value that is applied on the motor shaft. Some motors supply more than 160% torque. Consequently, the minimum
value and the maximum value depend on the minimum/maximum motor current as well as the motor used.
Table 308: Range:
Min: -30000 Nm
Max: 30000 Nm
Default value: 0 Nm
16-17 Speed [RPM]
Default value: 0 RPM
Parameter type: Range
2-setup: 1 setup
Conversion index: 0
Data type: int32
Change during operation: False
View the actual motor RPM. The motor RPM is estimated in open-loop process or closed-loop process control modes and the motor
RPM is measured in speed closed-loop mode.
Table 309: Range:
Min: -30000 RPM
Max: 30000 RPM
Default value: 0 RPM
16-18 Motor Thermal
Default value: 0%
Parameter type: Range
2-setup: 1 setup
Conversion index: 0
Data type: u_int8
Change during operation: True
View the calculated motor temperature in percentage of allowed maximum. At 100%, a trip occurs if selected in
parameter 1-90
Motor Thermal Protection
. The basis for the calculation is the ETR function selected in
parameter 1-90 Motor Thermal Protection
.
Table 310: Range:
Min: 0%
Max: 100%
Default value: 0%
16-22 Torque [%]
Default value: 0%
Parameter type: Range
2-setup: All setups
Conversion index: 0
Data type: int16
Change during operation: False
View the torque in percentage (in relation to the nominal torque) that is applied to the motor shaft.
Table 311: Range:
Min: -200%
Max: 200%
Default value: 0%
16-26 Power Filtered [kW]
Default value: 0 kW
Parameter type: Range
2-setup: 1 setup
Conversion index: -3
Data type: int32
Change during operation: False
Motor power consumption. The value shown is calculated on basis of the actual motor voltage and motor current. The value is
filtered, and a few seconds may pass from when an input value changes to when the data read-out values change.
Table 312: Range:
Min: 0 kW
Max: 1000 kW
Default value: 0 kW
AU363928304090en-000101 / 130R0982
148 | Danfoss A/S © 2021.07
Parameters
VLT® Flow Drive FC 111
Programming Guide
