DAHAO BECS-D16, Owner'S Manual, Page: 25 / 222

Chapter 2 Operation Instruction
If “ ” is chosen, the machine will remain in the preparation status. Even user
pulls the bar at this moment, the machine will not run and a prompt will appear to
ask the user to confirm embroidery.
2
）
Setting offset start point
After embroidery confirmation, if needed, click “ ” to set offset start point
according to the prompts. Note: It’s of no effect to set offset start point after
starting embroidery.
3
）
Setting the Way for Color-Changing and Starting
In the main screen, click “
” (or “ ”, “ ”),
the status will switch among
(auto color-change, auto start), (auto color-change, manual start) and
(manual color-change, manual start).
4
）
Setting Normal Embroidery and Idling
Click “ ” (or
,
) in the main picture and the status will switch
among (normal embroidery), (low-speed idling) and
(high-speed idling).
E. Pull the Bar for Embroidery
Operation bar( or embroidery bar) is installed under the table
BECS-D16 computerized embroidery machine owner’s manual 19