DAHAO BECS-D16, Owner'S Manual, Page: 143 / 222

Chapter 10 JF type sequin embroidery
(11) L/R Knife Start Angle Adj.
This parameter is for the special sequin device using the motor to cut the sequin,
which can adjust the start time of the sequin-cutting motor. The default value of
this parameter is 15. The smaller this value is, the earlier the motor will be
activated (Min value is 0); the larger this value is, the later the motor will be
activated (Max value is 31).
(12) Bead-breakage Detection Sensitivity.
This parameter is for the beam embroidery device. “0” means to turn off the
sensitivity of the beam-breakage detection. The range of this parameter is 0~10.
“1” means the highest sensitivity, while “10” means the lowest sensitivity.
(13) Motor Number of R (L) Sequin
This parameter should be set according to mechanism. If there is no sequin device,
you should set it as “0”.
Move the cursor to this parameter and press“ ”to enter. Use or to
modify the number and press “ ”to confirm.
(14) Set 3/4/5/6.75/9mm of R(L) Sequin
This is to set sequin-feeding angle. If the sequin-feeding device is roller type, the
parameter should be set as single way; if that device is lever type, the parameter
should be set as double way. The manufacturer should set it correctly before
selling the machine. The parameter is closely related to “left/right sequin device
A/B/C/D size and color”. For example, “A size&color of R sequin” is set as “4mm
X color”, then the corresponding sequin-feeding angle should use the value in “Set
4MM of R Sequin”.
BECS-D16 computerized embroidery machine owner’s manual 137