Chapter 2 Operation Instruction
No.
Display
Name
Description
Reference Section
4
Design
management
Press this key to enter into design
management interface, including
embroider design selection, input
design to memory, display design,
generate design, letter design operation,
etc.
Chapter 4
Disk management
Press this key to enter disk
management, including operations of
floppy disk and USB.
Chapter 3
Machine parameter
management
Press this key to enter into machine
parameter setting and operations.
Chapter 5
Go to start point
When the machine stops, press it to
have the frame automatically return to
the start point of the current design.
Go to stop point
When the machine stops, press the key
“Manual Frame-moving” to move the
frame (e.g. in case of patching). Then
press this key and the frame will
automatically return to the stop point of
the current design.
Turn main shaft
to100° manually
After stop, if the main shaft is not at the
right position, the figure will
sparkle.
;
Press the key and then the main shaft
will arrive to this position
.
trimming
After machine stops, user can press this
key to select to trim upper or lower
thread.
Hook/Flat needle
Press this key to shift between the flat
needle and hook needle.
Assistant
embroidery
operation
Design origin, needle stops down,
offset point, sequin, special embroidery,
etc.
Next group of
function key
Press this button to shift among
different function groups
Embroidery
preparation status
In embroidery preparation status, you
can select design, set parameter and etc.
Press this key and confirm, then
machine status is changed from
preparation status
to confirmation
status
.
BECS-D16 computerized embroidery machine owner’s manual
11
Summary of Contents for BECS-D16
Page 2: ......