Chapter 2 Operation Instruction
machine start normal embroidery. (When you pull the bar right and don't release it,
the machine will embroider in lower speed.) During the embroidery, pull the bar
left, the machine will stop.
After the machine stops, pull the operation bar to left and the frame will return to
its last position along original path. Pull the bar one time, the frame returns one
needle step. Pull the bar continuously and the frame will return one needle step
after another continuously. After the frame returns 10 needle steps continuously,
the frame can return continuously even when you release the bar. (This may be
different for different machine types). When the frame return continuously,
release the bar and pull it left again, the frame will stop returning.
The aim for returning is usually to perform mending embroidery. After the
returning stops, push the switch on machine head that needs perform mending
embroidery to go to the mending mode, and then pull the operation bar to right
and the machine head will start mending embroidery while other heads remain
inactive. When the frame goes to the point where the frame begins to return, other
heads whose mending switches are in normal embroidering mode will start to
embroider.
2-9
Relations between Normal Embroidery, Idling and Position Idling
Functions as idling, returning, etc. are intended for the convenience of patching.
Low-speed idling, high-speed idling or positioning idling can be used as needed
in embroidery. In the status of idling, the returning also has low-speed idling
returning, high-speed idling returning or positioning idling returning.
BECS-D16 computerized embroidery machine owner’s manual
23
Summary of Contents for BECS-D16
Page 2: ......
