DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
14
QOS COMMANDS
The QoS commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
config
bandwidth_control
<portlist>{rx_rate [no_limit | limit <value 8-524288>] | tx_rate [no_limit | limit
<value 64-524288>]}(1)
show
bandwidth_control
{ports <portlist>}
show 802.1p
user_priority
config
scheduling_mechanism {ports<porlist>} [sp | wrr]
show
scheduling_mechanism {ports<portlist>}
config 802.1p
default_priority
{ports <portlist>} [Low|Medium|High|Highest]
show 802.1p
default_priority
{ports <portlist>}
Each command is listed in detail, as follows:
config bandwidth_control
Purpose
To configure bandwidth control on the Switch.
Syntax
config bandwidth_control <portlist> {rx_rate [no_limit | limit
<value 8-524288>] | tx_rate [no_limit | limit<value 64-
524288>]}(1)
Description
The
config bandwidth_control
command defines bandwidth
control.
Parameters
<portlist>
- A port or range of ports to be configured.
rx_rate
- Enables ingress rate limiting
•
no_limit –
Indicates no limit is defined
.
•
limit <value 8-524288>
–
Indicates a range between 8-
524288 kbps.
tx_rate
– Enables egress rate limiting.
•
no_limit –
Indicates no limit is defined.
•
limit <value 64-524288>]
–
Indicates a range between
64-
524288 kbps
.
Restrictions
Only administrator-level users can issue this command.
69
