DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
11
NETWORK MONITORING COMMANDS
The Network Monitoring commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
show packet ports
<portlist>
show error ports
<portlist>
clear counters
{ports <porlist>}
clear log
show log
{index <value_list> | severity [all | informational | warning ]}
enable syslog
disable syslog
show syslog
config syslog host
[severity [informational | warning | all] | facility [local0 | local1 | local2 | local3 |
local4 | local5 | local6 | local7] | state [enable | disable] | udp_port
<udp_port_number> | ipaddress <ipaddr>]
show syslog host
cable diagnostic
[port <portlist> | all]
Each command is listed in detail, as follows:
show packet ports
Purpose
To display statistics about the packets sent and received in frames
per second by the Switch.
Syntax
show packet ports <portlist>
Description
The
show packet ports
command displays statistics about packets
sent and received by ports specified in the port list. The results are
separated into three tables, labeled A, B, and C in the window
below. Table A is relevant to the size of the packets, Table B is
relevant to the type of packets and Table C is relevant to the type of
frame associated with these packets.
Parameters
<portlist>
− A port or range of ports whose statistics are to be
displayed.
Restrictions
None.
Example usage:
To display the packets analysis for port 5:
52
