Coyote Point Systems E350GX, Installation And Administration Manual

Page: 68 / 344

Chapter 4: Equalizer Network Configuration
68 Equalizer Installation and Administration Guide
5. Click
commit
to create the VLAN.
Modifying a VLAN
Note that you cannot modify your VLAN configuration if failover is currently configured. This is because failover
depends upon the failover IP addresses assigned on each VLAN. The Disable Failover flag on the Failover Peers tab
allows you to temporarily disable failover in case you need to alter your VLAN configuration. See the section
“Disabling the Failover Configuration” on page 99.
1. Log into the Administrative Interface using a login that has
write
access for global parameters (see “Logging
In” on page 52).
2. Select
Equalizer > Networking > VLAN Configuration
.
Permissions:
Enable any, all, or none of these check boxes to allow GUI access to
Equalizer using the indicated protocols and IP addresses:
GUI http
HTTP on the VLAN IP.
GUI https
HTTPS on the VLAN IP.
GUI Failover http
HTTP on the Failover IP.
GUI Failover https
HTTPS on the Failover IP.
Enable
ssh
access to Equalizer via one, both, or neither of the
following IP addresses:
ssh
ssh on the VLAN IP.
Failover ssh
ssh on the VLAN IP.
port
status
type
Each row in the table at the bottom of the
Add New VLAN
screen
corresponds to a front panel
port
. For a new VLAN, all ports have the
status
unassigned
, meaning that they are not assigned to this VLAN.
Clicking the
assigned
button allows you to set the VLAN
type
for the
port:
tagged
or
untagged
. If a
type
appears with strikethrough text
(e.g., untagged), then that
type
cannot be selected for that
port
.
Note that it is not permitted to declare the same port as
tagged
in
one VLAN and
untagged
in another.