Club Car XRT 950 2009, Maintenance And Service Manual

Page: 183 / 256

SECTION 13 – ENGINE
13
DANGER
• See General Warning on page 1-2.
WARNING
• See General Warning on page 1-2.
This section contains information on removing and installing the Briggs & Stratton gasoline engine. For complete
instructions on engine disassembly, repair, rebuilding, and reassembly, refer to the engine manual.
See the Briggs &
Stratton Vanguard engine manual (CC P/N 103568101).
ENGINE REMOVAL
The engine can be removed through the top of the vehicle with the cargo bed and seat bottom removed.
1. Turn the fuel shut-off valve to the closed (OFF) position (Figure 3-2, Page 3-3) .
2. Run the engine until all fuel in the carburetor, fuel pump, and fuel lines is used and the engine stalls.
3. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
4. Lift and support the entire vehicle on jack stands and remove the rear wheels. See Lifting The Vehicle, Section
3, Page 3-4.
5. Remove the seat bottom.
6. Remove the cargo bed. See Cargo Bed, Section 4, Page 4-20.
7. Remove the three close out panels. See Under Seat Closeout Panels, Section 4, Page 4-12.
8. Remove the exhaust pipe heat shield (Figure 13-1, Page 13-1) .
9. Remove the driver side rear shock absorber. See Rear Shock Removal, Section 9, Page 9-1.
10. Remove the bolt securing the brake hose and cable to the driver side trailing arm (Figure 13-2, Page 13-1) .
1023
Figure 13-1 Remove Exhaust Heat Shield
1030
Figure 13-2 Detach Brake Hose And Cable From Trailing
Arm
11. Remove the clutch cover intake hose and the clutch cover. See Outer Clutch Cover Removal, Section 18,
Page 18-2.
12. Remove the drive belt. See Drive Belt Removal, Section 18, Page 18-3.
2009-2012 XRT 950 Maintenance and Service Manual Page 13-1