BRAKES
Troubleshooting
6
Park Brake Inspection
• Engage the park brake handle. When latched, the park brake should lock the wheels and hold the vehicle stationary
(on incline of 20% or less). If not, adjust the park brake.
See Park Brake Adjustment on page 6-25.
• Check the park brake cables, equalizer and linkage for damage. The cables should not come in contact with the
rear wheels, tires or suspension.
Brake Disc and Pad Inspection
• Inspect each brake disc. They should not be warped or have excessive scores or heat checks. Each disc should be
at least 0.150 inches (3.8 mm) at the thinnest point.
• Inspect each caliper. They should not hold the brake pads tightly against the disc when not in use.
• Inspect the brake pads for wear. The pads should not be glazed or soiled with grease or brake fluid. There should
be at least 0.020 inches (0.5 mm) of brake pad material at the thinnest point.
See following WARNING.
WARNING
• Use only approved replacement brake pads and/or shoes designed for this vehicle.
• Use only DOT 5 brake fluid.
• Do not pump brake pedal without fluid in the reservoir or master cylinder.
2009-2012 XRT 950 Maintenance and Service Manual
Page 6-5
